This thread is for the EQ tab — your own bands.
What it's for: the tuning you place by hand. Up to 128 bands per output, and every filter type there is — peak, low shelf, high shelf, low pass, high pass, band pass and notch — each with frequency, gain and Q. Any band can become one band per ear. Under the bands, the Tone row gives you Bass, Mid and Treble like an amplifier, with a low cut and a high cut either side.
How it works: your bands are one layer in the chain, with a switch of their own. The driver type, the headphone correction, the Tone, the preset and Smart EQ are separate layers, so clearing your bands never touches them, and every one of them can be switched off without being lost. Every layer feeds a single computed preamp: Auto normalize reserves headroom against the real combined response and against what the music actually needs, so stacking layers cannot clip you, and removing one gives the volume back. Everything belongs to the output you tuned it on — switch to your speakers and their sound comes back.
On the FluidEQ Engine the treble plays exactly as drawn up to 20 kHz, and every change crossfades instead of clicking; the EQ mode card lets you choose Equalizer APO's way of building the treble instead.
Ask here about bands, filter types, the Tone row, the preamp and Auto normalize. If the sound is wrong rather than the question, that is a bug — the issue tracker is the better place, so it does not get lost.
Rewritten for 2.1.